AR15 Billet 223 Upper Receiver. Slab side, no forward assist for a clean custom look.
Fits any forged or billet AR15 lower receivers.
Type 3 hard coat anodized for excellent strength and durability
May not work with some handguards that have rotational tabs.
For an exact fit try one of our lowers below
|Operation||Direct Gas Impingement|
|Material||6061 T6 Aluminum|
|Weight (ea)||7 oz.|
|Feed Ramps||Machined M4 style|
|Finish||Type III Anodizing|
Just received two more of these and as always, perfect. So far I have built four .223/5.56 complete AR's with these and the matching Lowers and they a truly sweet. Just ordered two 80% AR-10 Lowers and will be pre-ordering the new Noreen's AR-10 Billet Uppers. If they are a well done and as great a match to each other as the AR-15's are then I will be ordering five or six more complete sets of the AR-10 and the same of the AR-15's as well. Honestly the best 80%'s I've ever worked with. Great job Noreen Team.
Have used these before. Like the clean, sharp lines of the billet upper. Thess work especially well with UTG super slim hand-guards that have alignment tabs on them. Some minor modifications are still required but work great together.
One of the best if not the best upper out there
Perfect fit with the billet lower, best fitting and looking pair I have ever seen, tight tolerances and awesome finish, will only purchases these from now on. A+ company . Thanks
One of the best uppers I have seen. Literally nothing removed to true the journal face.(I use a lathe). Assembled perfectly, looks awesome, one cannot go wrong ordering one of these.
Sweet upper nice Machining work looks great would buy again. Price is right too
The best out there
I spent a long while researching uppers before I settled on this one, and I'm glad I did. I may have to buy a second one for a future build! A note about handguards with anti-rotation tabs: This billet upper is thinner in that area than other billet uppers, but not as thin as a forged upper. My chosen handguard didn't fit immediately. I spent a couple minutes trimming the inside of the anti-rotation tabs and now the two components fit perfectly. You can't even tell I had to do that from looking at the upper. Much better than having to trim off the tabs entirely, as with some other billet uppers!
This is an absolutely amazing Upper. I have purchased from almost every manufacturer known and these people are second to none. The machining is perfect, the fit is exact and the finish is every bit as good as Uppers costing 100's more. Noreen Uppers and Lowers are the only ones I will ever purchase from now on. I received 2 Uppers today and next it's 2 Lowers. Then it will be time to get several Raw Uppers and Lowers. Noreen Firearms, my new best friend. Thank you for being the best at what you do.
I just love the quality, finish and design of these uppers! And, I like the fact there is no Forward Assist!. The overall U/L fit is also excellent each time.